Primary tabs
Passivate - 1 SS Cleaner
Superficial rust, oil, grease and lime deposits can occasionally appear on any stainless steel surface. Cleaning with Rxsol Passivate 1 eliminates these spots with ease, restoring the surface and returning your stainless steel to its original lustrous look, feel and finish.
Rxsol Passivate 1 is intended for a wide range of industrial cleaning applications, it offers a good general cleaning result on stainless steel surfaces.
Rxsol Passivate 1 can be used in combination with Passivation Spray , which helps to remove free iron from the surface and regenerate the protective layer in the stainless steel by speeding up the passivation process.
1. Apply the Cleaner with a brush or by spraying or dipping.
2. When spraying, use an acid-resistant pump.
3. Leave the fluid to work 15 to 30 min at room temperature.
4. Rinse thoroughly with a high-pressure water jet. Treat the waste water before discharge
Features & Benefit :
- Restores and brightens stainless steel surfaces that have been contaminated during fabrication or usage. It removes surface rust, water staining and lime deposits and organic contamination such as oil and grease.
- Pre-cleans before pickling. It removes organic contaminants such as grease, oil, etc. which will inhibit pickling.
-
Removes atmospheric staining caused by sea water, “teastaining”, rain water, “water scale” and road salt.
Storage:
Rxsol Passivate 1 should be stored indoors at room temperature. Containers must be kept properly closed, in an upright position and inaccessible to unauthorised persons. The products are perishable and should not be kept in storage longer than necessary. They have a maximum shelf life of two years when stored at room temperature. Exposure to higher temperatures may reduce shelf life
Handling :
Protective clothing. In general users should wear acid-resistant overalls, gloves and rubber boots. Face visor should be used and, if necessary, suitable respiratory protective devices. Special conditions may apply from one country to another. Refer our Material Safety Data Sheets.
Packing : 5 Kgs, 10 Kgs, 230 Kgs.
|
Appearance |
: |
Transparent liquid |
|
Odour |
: |
Slight smell |
|
Boiling point |
: |
80-100oC |
|
Flash point / Explosion properties |
: |
Not applicable |
|
Specific temperatures |
: |
Solid-fluid 0oC, Fluid-gas 80-100oC |
|
Vapour pressure at 20oC |
: |
< 0.01 kPa |
|
pH |
: |
0,6 at 20oC |
|
Density |
: |
1.1 g/cm3 at 20oC |
|
Solubility in water at 20oC |
: |
100 weight % |