Primary tabs
RXSOL Altreat 400
RXSOL Altreat 400 is a new generation Antiscalant and antifouling agent for for Distillation Plant, RXSOL Altreat 400 helps to maintain Cost-effective recovery of fresh water from seawater and it is critical to a wide range of industries such as the power, chemical, marine, oil and gas industries.
RXSOL Altreat 400 scale inhibitor is a polycarboxylic acid that controls inorganic scale formation. Small amounts of this copolymer, based on maleic acid, effectively handles large quantities of dissolved salts, thus preventing precipitation,settling and baking onto heat transfer surfaces.
Instructions for use
- Normal dosing rate 2–10 ppm (max. 10 ppm), depending
- on the properties of the water to be treated. Ensure adequate mixing at chemical tank before dosing into the system.
-
Recommended operating temperatures: 50°–80°C.
The typical dosage to feedwater ranges from a minimum of two parts per million (ppm) to a maximum of 10 ppm, depending on the quality of the seawater.
During the distillation process, the formation of scale on heat transfer surfaces can significantly reduce heat transfer efficiency and increase operation and maintenance costs. Scale formation depends on temperature, concentration and pH, but generally takes the form of:
- Calcium carbonate,
- Magnesium hydroxide, and,
- Calcium sulphate.
Conventional scale inhibition methods, such as the use of sulphuric acid and polyphosphates, have given rise to a new generation of antiscalants based on polycarboxylic acids.
- Highly concentrated liquid delivers substantial savings since up to 40% less solution than other polymaleates is required to achieve the same effect.
- Highly effective, but gentle, solution does not harm the environment or heat exchanger tubes, plates, gaskets or glue.
- Highly versatile scale inhibitor delivers effective performance while operating in temperatures up to 80ºC.Helps maintain heat transfer rates, thus improving process performance, reducing energy costs and prolonging heat exchanger lifetime.Increases the efficiency and performance of the equipment,reducing total operation and maintenance costs.
- Recommended operating temperatures: 50°–80°C.
specification:-
| Appearance: | Colourless |
| Specific gravity (water=1) | > 1 |
|
Viscosity: |
600 mm2/s at 23°C |
| Flash point: | >100°C |
| pH: | 6-8 |
| Miscibility with water | In all proportions |