Rust Remover - Chemical Rust Remover supplier ,Manufacturer from visakhapatnam India

RUST REMOVER is a concentrated aqueous liquidsolution consisting of a blend of synergetic antioxidants and passivators. It is used to remove rust from any steel surface area and rust stains from brass, copper, stainless steel, wood, ceramic and aluminum surfaces, painted or not. Additionally, itcontributes to the rust proofing of metals beforeany painting or coating application. 

Rust is an iron oxide, a usually red oxide formed by the redox reaction of iron and oxygen in the presence of water or air moisture. Several forms of rust are distinguishable both visually and by spectroscopy, and form under different circumstances. Rust consists of hydrated iron(III) oxides Fe2O3·nH2O and iron(III) oxide-hydroxide (FeO(OH), Fe(OH)3).

 Rust Remover is a phosphoric acid based concentrate used to remove rust and toclean metal surfaces. It cleans tarnish, oxidation, stains, fingerprints and scale from iron,
steel, copper, brass and aluminium.

ADVANTAGES AND CHARACTERISTICS

•Readily removes rust and rust stains from metal
and non–metal surfaces.

•Protects and keeps surfaces free from corrosion.

•Removes and prevents flash and light rust due to
passivation.

•Acts as a rust proofing agent before the application of paints or coatings.

•Non–flammable, does not affect rubber or plastic compounds.

•May be used with a specific range of other cleaning products.

•Cost effective, easy to apply and use

APPLICATION AND USE

A. Dosing Procedure

The quantity of RUST REMOVER to be used cannot
be directly specified, since it depends on the cleaning results desired and the situation at hand. Theuser is the one responsible to regulate the quantityneeded. However, when the cleaning application isdetermined, RUST REMOVER must be used dilutedwith fresh water with a percentage concentration
ranging between 10–50% depending on the desired strength of the solution.Note that a 10% solution is sufficiently strong and
it can be used for most general/everyday situations involving rust.The 50% solution is recommended when we have
very difficult cases, involving areas that are very
heavily encrusted with rust. 

B. Cleaning Procedure

Before application, when the affected area has
been determined, ensure the absence of oil,grease, dirt or other foreign matter. Then shake the RUST REMOVER well and prepare the desired concentration solution.The solution may now be applied either by brushing and/or injection.Smaller parts may be immersed directly into theprepared solution.In all of the above situations, you must allow RUSTREMOVER to act for 20–40 minutes and then rinse thoroughly with high or regular pressure fresh water.
Note that in cases for where RUST REMOVER has been specifically used to rust proof an area, before
it is to be painted or coated, there is no need to rinse with water. Possible work pieces for the process "Decoating"

APPLICATIONS

• Rust and scale removal from :
ferrous metals
non-ferrous metals

• Oxidation and stains removal from :
aluminium
copper
brass, ...

• Metals preparation prior to painting

• Cleaning of :
in-process parts and assemblies
sheet metal

• Restoration of rusted parts.

• Removal of metal and rust stains from porous materials.