Primary tabs
RXSOL Marine Concentrate
Using-Procedure:-
Recirculation Method :::-First of all flush the system with cold water to prevent evaporation rates and polymerization. then make a mixture of 0.2-0.5 % RXSOL Marine Concentrate with fresh water. Re-circulate for 2-4 hours with a temperature of 20-60 oC.(depending on previous cargo) the most economical method of using RXSOL Marine Concentrate is by direct injection followed by recirculation washing, using tank cleaning machines.
Spraying Method:-Using RXSOL Marine Concentrate as delivered in drums, spray onto areas where residue remains following rough washing leave for 10-45 minutes (but do not allow to dry), then butterworth at maximum pressure and warm water 60oC for at least 3 hours, checking that there is no foam remaining in the final stages. Inspects tanks(s) and if desired result has been achieved fresh water rinse and dry.
**Make sure to take all safety precautions are followed when handling / spraying RRXSOL Marine Concentrate
Injection Method:- Not applicable.
Tank Cleaning Sludge/ Lube Oils / Slope-Black Oil
Other Popular Method for TANK CLEANING :::
2nd Re- Circulation Method:- Fill tank with fresh water and heat up to warm 50oC . IF a drop line is available on the tank line system, then start to circulate the water and add the required amount of Caustic flakes and RXSOL Marine Concentrate to make a 2.5% solution. A stronger solution can be made, but be advised that too much Caustic and too high temperature will result in white powder all over the tank. Under normal circumstances, between 2.5% and 4.5% will be sufficient strength. If there is no drop line, then lower butterworth hoses into the tank from the pump stack header without machines attached and circulate through these hoses while you fill the solution material.
Colorless to light yellow liquid,
Odour: citrus.
Flash point (PMCC) : >50 oC
pH (1% Solution) : 9.0
Suitable for use on most metals.