Primary tabs
Cold Washer HD
Ready to use for tank cleaning or general degreasing.
Complete removal of dirt, oil, carbonized grease, heavy oil, gum, vegetable oil, Lube oil, soot, asphalt, paraffin, carbon stains etc. Gives clear finish to the surface. Highly effective for the removal of crude and other high melting point stains.
|
SPRAY METHOD |
Mix 1 part of RXSOL-20-2003-CW with 2 -10 parts of water / GAS-OIL ( For heavy oil,greasy surface use directly)Spray directly on the entire surface to be cleaned. This can be achieved by Hand spray / mechanical spray pump. Immediately after 2 -5 minted of spray the RXSOL-20-2003-CW starts its function. The Dirt, oil grease etc will loosen. 5 to 6 minutes after spraying start rinsing the system with water (High pressure recommended). Dirt and mud starts vanishing with cleaning media and water |
|
Immersion Method |
Application in immersion process with or without ultrasonic support, manual wipping. |
|
RE-circulation Method |
RXSOL-20-2003-CW is also used in conjunction with alkaline degreasing bath at 2-10% (v/v) concentration for better and quick degreasing action. Eithers the bath is heated to be 70°Cor the solution can be stirred or air agitated. FINALLY RINSE THE SYSTEM WITH FRESH WATER. |
Advantages :
RXSOL-20-2003-025 is easily soluble in water Action is quite fast even at low temperature which gives advantages of cleaning under operation And avoid shut down and down time.Non corrosive to most of the metals / plastics. Gives clear finish to the surface .Lower cost due to high concentration
| Appearance | Clear amber brown liquid | |
| Density | In g/cm3 at 15°C: 0.95b | |
| Flash Point | Above 70°C ( on dilution with water more than 90°C ) | |
| Compatibility | ||
| Metal | No known effect | |
| Rubber | May swell | |
| Synthetic rubber | May swell | |
| PACKAGING | Order No: RXSOL-20-2003-CW | Size (in litres): 25,/30,/210 |
AVOID contact of RXSOL-20-2003-025 with skin or eye Contact. If contact occurs wash with ample quantity of water. NOTE : on dilution RXSOL-20-2003-025 is more effective and safe for use on epoxy, polyurethane, zinc-silicate coatings and stainless steel.