ALKACLEAN s. LAC

← Back to all products
RXSOL product image coming soon
Request a Quote Email usvizagchemical @ gmail.com DocumentsRequest MSDS / TDS
Ship Hold Cleaner-22

ALKACLEAN s. LAC

SKU: RXSOL-22-2015-210
A very strong alkaline cleaner, which can be used to soften up / remove baked on drying oils
Pack Size / Specification:
20 Ltrs, 25 Ltrs. alkaline tank cleaner, sodium hydroxide based. A very strong alkaline cleaner, which can be used to soften up / remove baked on drying oils
Enquire About This Product →

Technical Specifications

  • Removes grease, oil, carbon deposits, soil and grime.
     
  • Keeps loosened deposits in suspension preventing re-deposition.
     
  • Low toxic.  , Non-flammable.
     
  • Free from hydrocarbon solvents.
     
  • Effective and economical in use , Water-based cleaner.
     
  • RXSOL-20-2015-020 has numerous cleaning applications including removal of greases, waxes,
     
  • oil, sludge, soot, carbon   deposits and general dirt and grime.
     
  • Non-corrosive to ferrous metals.  Suitable for all tank-coatings.
     
  • Can be used for gas and hydrocarbon freeing of tanks.
     
  • Can be used for deodorizing
     
  • Contains wetting agents.


NOTE : Acts as an acid-neutralizing agent.

Application & Dosage

It can be used as a general purpose cleaner to remove oil and grease deposits.First of all flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of using RXSOL-20-2015-020 is by direct injection followed by recirculation washing, using tank cleaning machines. Spraying Method  - Using LAC as delivered in drums, spray onto areas where residue remains following rough washing leave for 10-45 minutes (but do not allow to dry), then butterworth at maximum pressure and warm water 60oC for at least 3 hours, checking that there is no foam remaining in the final stages.  Inspects tanks(s) and if desired result has been achieved fresh water rinse and dry.

** Make sure to take all safety precautions are followed when handling / spraying RXSOL-20-2015-020

Injection Method – not applicable.

Refer to technical datasheet

Related Information

Re-circulation Method :
Fill tank with fresh water and heat up to warm 50 oC .IF a drop line is available on the tank line system, then start to circulate the water and add the required amount of Caustic flakes and LAC to make a 2.5% solution.  A stronger solution can be made, but be advised that too much Caustic and too high temperature will result in white powder all over the tank.  Under normal circumstances, between 2.5% and 4.5% will be sufficient strength.  If there is no drop line, then lower butterworth hoses into the tank from the pump stack header without machines attached and circulate through these hoses while you fill the solution material.

* Use a strainer at the pump stack when circulating any solution.*
  Tank Lining – Stainless / Epoxy / Phenolic